Showing posts with label Temperature-Control. Show all posts
Showing posts with label Temperature-Control. Show all posts

Friday, April 08, 2016

Blind Dial Proportional Temperature Controller

This is a Low cost controller, Analog Dial Temperature Controller. It is also called Blind Controller. This essentially means Open Loop, just control the fuel or energy input to the system to regulate heat. This is not a Blind Controller that way, it only cannot display the temperature value, that could be another reason it is called blind.

Blind Dial Proportional Temperature Controller

Blind Temperature Controller

Dial cyclic timers were used to control heat, these were purely mechanical clockwork devices. They could regulate well, when the material flow (liquid) is constant and mains power is regulated. But when the job to be heated, varies in quantity, control temperature is close to ambient or when a precise control is required; closed loop controllers are used. Even a thermostat is like closed loop, as the bimetallic sensor is temperature dependent. But not good enough.

This controller is closed loop, precision controller, only the digital display of temperature is absent. Fine one deg variations may not be easy in this.

Blind Dial Proportional Temperature Controller

Blind Dial Proportional Temperature Controller

Friday, February 10, 2012

Temperature Control - Part 2

A Two Point Process Controller or Temperature Controller would look like this. When a High-Low Alarm Protection for uC based Controller was needed the same was modified and used.

Sometimes uC based instruments just forget and that can be costly, the watchdog timer has solved this problem. In Industrial Process Control we cannot take any chances, so a two tier or even three tier protection is required, especially so if the Job or Raw material being processed is expensive. So Real Time Analog Trip + uC Controller is safe. Then you can still have Electro Mechanical Devices for Extra protection against Fire or Meltdown.

Two Setpoint Temperature Controller

Temperature is the most common process parameter, Pressure seems to be next. Flow, Level, RPM, Distance and many more follow.

When a physical parameter let us say distance is measured, we first need a sensor that converts it into electrical values, digital or analog. The sensor used for length is a Linear encoder and it creates the electrical information for the DRO to Display.

Now many sensors like a strain gauge produce very low and weak signals and some are non-linear. So the signals undergo Amplifying, Temperature compensation and Linearizing together called Signal Conditioning. This stage outputs some standard values like 4-20mA, 0-10 V, 1-5V, or even directly digital or wireless in the new technologies. Even when a digital interfacing standard is used, amplification and some signal conditioning is required at sensor end. Compensation and Linearizing can be better done with a uC using Math or Look up Tables.

When you have many different parameters then it is better to use process controllers with a 4-20mA input standard. Then the inventory of controllers can be reused for any process.

It is always better to use sensor-end transmitters to get 4-20mA to your Controller, Recorder or SCADA System.Weak signals are corrupted by noise and dont travel long wire distance. Junction EMF at joints and terminal blocks add to errors. These are overcome by the 4-20mA signal that has the juice and punch to transmit the data over the shop floor to the control panel rooms.

Read more here Temperature Measurement and Control

Monday, January 30, 2012

Temperature Control in Automation

Temperature Controller 48-96 - A 1/8 DIN Indicating Temperature Controller. This is a Analog Controller built around ICL7107.

Temperature Measurement and Control

48 96 Temperature Controller

This is a 48-96 DIN Temperature Controller, it is mains operated, it is in a Industrial Plastic Housing. It is not meant for very harsh environments. Suitable for Control Panels in Control Rooms. It has a accuracy and linearity of 0.5%. It had options of on-off or time proportional control.

Complete designs and PCB of a Generic Analog Controller

Main Cards having Power Supply and Digital Display

Signal Conditioning and Control Modules on BergStick/soldering.