Also Visit EE delabs and Hobby DIY Garage. The EE Widgets are at dapj Widgets.

Thursday, November 06, 2014

Buffer Unity Gain Amp - Op-Amp Designs

If output impedance of a point is a high value then connecting another circuit at that point will load it, resulting in malfunction or error. Buffers are used as interface between circuits.

Low impedance of an output means it can source/sink lot of current, when you need 2 opamps use LF353 or TL072 which are dual opamps.

Buffer Unity Gain Amp - dapj Tech Widgets

Buffer Unity Gain Amp - Op-Amp Designs

A non-inv FET input is the best buffer, for inverting buffer use high R values. Using very high R values like 2.2M or higher requires a glass epoxy PCB and guard rings around pin 2, 3 to prevent leakage currents on the PCB reaching the PINs.

Also moisture and dust has to be prevented by using RTV coating or Varnish. Use 78L05 and 79L05 for the dual supply required by this circuit.

Inverting Amp   -   Vout = -1 * Vin

Non-Inverting Amp   -   Vout = Vin

Vary the Millivolt Source by just hovering your Mouse pointer over the Two Buttons (Increment and Decrement). If you leave the mouse pointer on a button, the variation will pick up speed. Set a Value of your choice, positive or negative, you can set from -199.9mV to +199.9mV. Note the Output values on both the DVMs on the right (digital Volt Meter) in a Table. Repeat this for at-least 7 readings of both polarities. Jot the Formula below in your book and relate it to your table.

No comments:

Post a Comment

delabs Tech

delabs Tube



More at delabs Tube